Grand Vitara 4WD V6-3.2L (2010)
Cruise Control Switch: Testing and Inspection
Cruise Control Switch Inspection
NOTE: Never disassemble cruise control switch. Disassembly will spoil its original functions.
1. Remove driver air bag (inflator) module referring to Driver Air Bag (Inflator) Module Removal and Installation:Advanced Air Bag or Driver Air
Bag (Inflator) Module Removal and Installation:Except Advanced Air Bag.
2. Disconnect cruise control switch connector (1) from control coil.
3. Check cruise control switch as follows.
For MAIN (ON/OFF) Switch
Check for continuity between "1" and "8" terminals under each condition below. If check result is not satisfactory, replace cruise control switch (2).
Cruise MAIN (ON/OFF) switch (3) specification: [B]
Switch button released: Infinity
Switch button pressed: Continuity
For SET/COAST, RES/ACC and CANCEL Switch
Check for resistance between "7" and "9" terminals under each condition below. If check result is not satisfactory, replace cruise control switch (2).
SET/COAST, RES/ACC and CANCEL switches resistance: [C]
All switches released (OFF): Infinity
CANCEL switch (4) pressed (ON): About 0 Ohms
SET/COAST switch (5) pressed (ON): 218 - 222 Ohms
RES/ACC switch (6) pressed (ON): 901 - 919 Ohms