Grand Vitara 4WD V6-3.2L (2010)
Camshaft Position Sensor: Service and Repair
Camshaft Position (CMP) Sensor Removal and Installation
NOTE: For identification of each cylinder and bank, refer to Precaution for Identification of Cylinder and Bank:N32A.
Removal
1. Disconnect negative cable from battery.
2. Disconnect CMP sensor connector.
3. Remove CMP sensor from timing chain cover.
Installation
1. Reverse removal procedure noting the following.
-
Apply engine oil to O-ring of sensor.
-
Tighten new CMP sensor bolt (3) to specified torque.
Tightening torque
CMP sensor bolt (a): 10 N.m (1.0 kg-m, 7.5 lbf-ft)