Grand Vitara 4WD V6-3.2L (2010)
Keyless Start Transmitter: Service and Repair
Registration Procedure For Remote Controller ID Code
Registration Procedure for Remote Controller ID Code
NOTE:
-
It is possible to register up to 4 remote controllers in keyless start control module.
-
Setting keyless start control module to ID code registration mode of remote controller will erase all remote controller ID codes that have been
registered in keyless start control module.
Therefore, when registering remote controller ID codes in keyless start control module, have all of those to be registered ready and execute their
registration at the same time.
-
When registration of more than four remote controller ID codes is attempted, the oldest remote controller ID code will be erased and that inputted
after the fourth one will be registered.
-
When keyless start control module which was used in another vehicle has been installed, register the ID code of the remote controller to the
keyless start control module first and then the following code.
-
With immobilizer control system, register the ignition key transponder code for the immobilizer control system in ECM. For registration
procedure of that, refer to Registration of the Ignition Key.
-
Without immobilizer control system, register the steering lock unit ID code in keyless start control module. For registration procedure of that,
refer to Keyless Start Registration.
If remote controller or keyless start control module is replaced with a new one or additional remote controller is necessary, register ID code(s) of remote
controller.
1. Sit in driver seat and close all doors.
2. Check that door lock of driver seat is unlocked.
3. Insert ignition key (1) into ignition key cylinder.
4. Perform Steps a) through f) described below within 25 seconds after Step 3).
a. First push manual door lock switch (3) toward lock side (3) and then push it toward unlock side (4).
b. Repeat Step a) 2 more times.
c. Push lock side of manual door lock switch.
d. Remove ignition key from ignition key cylinder once and then insert it again.
e. Repeat Step d) 3 more times.
f.
Start engine and wait for 3 seconds.
