Grand Vitara 4WD V6-3.2L (2010)
Starter Motor: Overhaul
Starting Motor Inspection
Starting Motor Operation Check
CAUTION:
-
When using battery, do not create short circuit between terminals together.
-
Each test must be performed within 3 - 5 seconds to avoid burning of coil.
1. Perform pull-in test as follows.
a. Disconnect lead wire (3) from terminal "M" (2).
b. Connect battery to magnetic switch as shown in figure.
c. Check that plunger and pinion move outward.
If plunger and pinion do not move, replace magnetic switch.
2. Perform hold-in test as follows.
a. From the state of step 1) with plunger and pinion in "out" position, disconnect negative (-) lead from terminal "M".
b. Check that plunger and pinion remain in "out" position.
If plunger and pinion return inward, replace magnetic switch.
