Grand Vitara 4WD V6-3.2L (2010)
3) Installing coil spring (1) on lower arm and place coil spring end (3) onto lower arm (2) as shown in figure.
CAUTION:
^
Flat end coil spring is upward.
^
Upper end of coil spring has to be firmly mated to coil spring rubber seat.
^
Install end of coil spring (3) positioned 5 mm (0.19 in) away from step of spring lower seat (4).
4) Support lower arm (2) with jack (5).
5) Hoist jack and then install lower arm outer bolt (6) and tighten bolt temporarily by hand.
CAUTION:
If lower arm outer bolt is reused, apply engine oil to thread, bearing and trunk surface.
