Grand Vitara 4WD V6-3.2L (2010)
4) Remove floor jack from lower arm.
5) Install rear wheels and lower hoist.
6) Tighten trailing rod mount nut and trailing rod rear bolt to specified torque with vehicle weight on suspension.
CAUTION:
It is the most desirable to have vehicle off hoist and in non-loaded condition when tightening them.
Tightening torque
Trailing rod mount nut: 135 Nm (13.5 kg-m, 98.0 lbf-ft)
Trailing rod rear bolt: 135 Nm (13.5 kg-m, 98.0 lbf-ft)
7) Check rear toe and camber adjust it as necessary. For check and adjustment procedures, refer to Rear Wheel Alignment Inspection and
Adjustment.
