Grand Vitara 4WD V6-3.2L (2010)
Fluid - A/T: Procedures
4-Speed Automatic Transmission
A/T Fluid Level Check
At Normal Operating Temperature
1) Drive vehicle so that A/T fluid temperature reach the normal operating temperature (70 - 80 degrees C (158 - 176 degrees F)).
2) Stop vehicle with engine running and place it level.
3) With select lever at "P" range, apply parking brake and place chocks against wheels.
4) Keep engine idling and shift selector slowly to "L" and back to "P" range.
5) With engine idling, pull out dipstick (1), wipe it off with a clean paper towel and put it back into place.
6) Pull out dipstick (1) again and check fluid level indicated on it. Fluid level should be between FULL HOT and LOW HOT. If it is below LOW
HOT, add specified A/T fluid up to FULL HOT.
A/T fluid specification
SUZUKI ATF 3317 or Mobil ATF 3309
NOTE:
^
DO NOT RACE ENGINE while checking fluid level, even after engine is started.
^
DO NOT OVERFILL. Overfilling can causes foaming and loss of fluid through breather. Then slippage and transmission failure can result.
^
If vehicle was driven under high load such as pulling a trailer, fluid level should be checked about half an hour after it is stopped.
^
When checking oil level, oil level gauge must be used in proper direction. Insert oil level gauge so that its front or back face is directed to the
front of vehicle. When oil level indicated on front face of oil level gauge differs from that on back face, use lower one.