Grand Vitara 4WD V6-3.2L (2010)
Installation
Install drive shaft assembly by reversing removal procedure and noting the following points.
CAUTION:
^
Protect oil seals and boots from any damage, preventing them from unnecessary contact while installing drive shaft.
^
Do not hit joint boot with hammer.
Inserting joint only by hands is allowed.
^
Tighten rear drive shaft nuts to specified torque.
^
Tighten left side lower arm outer bolt, trailing rod rear bolt and control rod outer bolt to specified torque.
^
Tighten rear wheel speed sensor bolt to specified torque.
^
Fill rear differential with oil as specified.
