Grand Vitara 4WD V6-3.2L (2010)
Clutch Pedal Position Sensor / Switch: Testing and Inspection
Clutch Pedal Position (CPP) Switch (for 4WD Control Module) Inspection and Adjustment
Inspection
Check for resistance between terminals under each condition below. If check result is not satisfactory, replace.
Clutch pedal position (CPP) switch (for 4WD control module) resistance
When switch shaft is pushed (1): Continuity
When switch shaft is free (2): No continuity
Adjustment
1) Loosen lock nut of clutch pedal position (CPP) switch (for 4WD control module) (1) while clutch pedal not depressed.
2) Using ohmmeter, adjust position of clutch pedal position (CPP) switch (for 4WD control module) so that it may become continuity within range of
clutch pedal travel "a".
Clutch pedal travel "a": 116 - 130 mm (4.52 - 5.11 in.)