Grand Vitara 4WD V6-3.2L (2010)
Transmission Temperature Sensor/Switch: Service and Repair
4-Speed Automatic Transmission
Transmission Fluid Temperature Sensor Removal and Installation
Removal
1) Remove solenoid valves.
2) After removing bolt (1) pull out solenoid connector (2) from transmission case.
CAUTION:
When pulling solenoid wire harness out of transmission case, take care not to damage connectors and transmission fluid temperature
sensor at narrow exist of case. Careless sensor treatment might cause sensor malfunction.
Installation
Reverse removal procedure to install transmission fluid temperature sensor, noting the following points.
^
For details of solenoid valves and their connectors installation, refer to Automatic Transmission Unit Assembly: 4 A/T. Use new O-ring.
^
For details of A/T oil pan installation, refer to Automatic Transmission Unit Assembly: 4 A/T
^
Fill A/T fluid and check fluid level according to procedure described in A/T Fluid Change: 4 A/T.
^
Check for fluid leakage after warming up A/T.
^
Tighten solenoid connector bolt to specified torque.
