Grand Vitara JLS 2WD V6-2.5L (2001)
Brake Switch (Cruise Control): Testing and Inspection
Stop Lamp Switch (With Pedal Position Switch)
1. Disconnect negative (-) cable at battery.
2. Disconnect stop lamp switch connector and remove stop lamp switch from pedal bracket.
3. Check switch (2 contacts) for resistance under each of the following each conditions.
If check result is not satisfactory, replace stop lamp switch.
Stop lamp switch specification
Between terminals "1" and "3" (Contact for stop lamp)
FREE (2) : Continuity, PUSH (1) : No continuity
Between terminals "2" and "4" (Contact for brake pedal position)
FREE (2) : No continuity, PUSH (1) : Continuity
4. Install stop lamp switch and adjust its position.
