Grand Vitara JLS Plus 2WD V6-2.5L (2000)
1. When positioning thermostat and O-ring on thermostat case, be sure to position it so that
^
air bleed valve comes at top (G16 engine)
^
air bleed valve comes at match mark and into the recession of thermostat case (J20 and H25 engines).
2. Install thermostat cap to intake manifold (G16 engine), water pump (J20 engine) or thermostat case (H-25 engine).
3. Install cooling fan and fan shroud and connect radiator inlet hose to radiator (H-25 engine only).
4. Fill cooling system. Refer to "COOLANT" and steps 8. to 10. of "COOLING SYSTEM FLUSH AND REFILL" located under Cooling System.
5. Connect negative cable at battery.
6. After installation, check each part for leakage.
