Grand Vitara JLS Plus 2WD V6-2.5L (2000)
Special Tool
(B): 09944-36011
(C): 09926-58010
15-1.Disconnect CKP sensor connector and remove CKP sensor if necessary.
16. Remove timing chain cover.
CLEAN
Clean sealing surface on timing chain cover, crankcase, cylinder block and cylinder heads.
Remove oil, old sealant, and dust from sealing surface.
INSPECTION
Check oil seal lip for damages or deterioration. Replace as necessary.
NOTE: When installing new oil seal, top it in until its surface is flash with edge of timing chain cover. To install oil seal, use special tool (bearing
installer).
Special Tool
(D): 09913-75510
INSTALLATION
Reverse removal sequence to install timing chain cover noting following points.
1. Apply sealant "A" to timing chain cover sealing surface area as shown in figure.
"A": Sealant 99000-31150
2. Apply engine oil to oil seal lip and water pump 0-ring, then install timing chain cover.
Tightening Torque (d): 11.0 Nm (1.1 kg-m, 7.5 ft. lbs.)
