Grand Vitara JLS Plus 2WD V6-2.5L (2000)
Drive Belt: Adjustments
COOLING FAN BELT TENSION CHECK AND ADJUSTMENT
WARNING: Disconnect negative cable at battery before checking and adjusting belt tension.
[G16 AND H25 ENGINES]
1. Inspect belt for cracks, cuts, deformation, wear and cleanliness.
2. Check belt for tension. Belt is in proper tension when it deflects 6 to 8 mm (0.24 - 0.32 inch) under thumb pressure (about 10 kg or 22 lb.).
Belt tension "a":
6 - 8 mm (0.24 - 0.32 inch) (G16 engine)
9 - 11 mm (035 - 0.43 inch) (H-25 engine)
as deflection/10 kg (22 lbs)
NOTE: When replacing belt with a new one, adjust belt tension to 5 - 7 mm (0.20 - 0.27 inch) (G16 engine) or 7 - 9 mm (0.27 - 0.35 inch)
(H-25 engine).
3. If belt is too tight or too loose, adjust it to proper tension by displacing generator position.
4. Tighten generator adjusting bolt and pivot bolt.
5. Connect negative cable at battery terminal.
