Grand Vitara JLS Plus 2WD V6-2.5L (2000)
Vehicle Speed Sensor: Testing and Inspection
Voltage Inspection
On-Vehicle Inspection
1. Hoist vehicle.
2. Release parking brake lever, set transmission in neutral and transfer in "2H".
3. Remove ECM (PCM) cover.
4. Connector voltmeter between VSS terminal C51-3-1 of ECM (PCM) connector and body ground.
5. Turn ignition switch ON and turn rear right tire slowly with rear left tire locked.
Voltmeter should indicate deflection between 0 - 1 V and 8 - 14 V a few times while tire is turned one revolution.
If check result is not satisfactory, proceed to flow table of DTC P0500 in Computers and Controls; Testing and Inspection; Procedures; Diagnostic
Trouble Code Procedures.
