Grand Vitara JLS Plus 2WD V6-2.5L (2000)
Leak Detection Valve: Testing and Inspection
EVAP Leakage Inspection
1. Disconnect purge hose from intake manifold and tank pressure control valve hose from solenoid vacuum valve.
2. Turn EVAP canister purge valve ON (open) using SUZUKI scan tool or service wire.
3. Plug air valve hose end.
4. Connect vacuum pump gauge to disconnected tank pressure control valve hose end. And apply vacuum to tank pressure control valve.
5. Apply 3.5 kPa (14.0 in Aq, 26.0 mmHg) to purge hose and seal it.
After 15sec., check to make sure that pressure is higher than 3.3 kPa (13.6 in Aq, 24.5 mmHg).
If check result is not satisfactory, locate pressure leaking point by using soap water or leak detector.
If no pressure leakage exists in vapor purge line, fuel filler cap, filler neck and etc., remove fuel tank from vehicle and check for leakage from
installation face of parts installed on fuel tank and hose joint.
