Grand Vitara JLS Plus 2WD V6-2.5L (2000)
4. Install lower part of shock absorber to right and left sides of axle housing and install bolts in proper direction as shown in figure. At this time,
mount nuts but don't tighten them.
5. Clean mating surfaces of axle housing and differential carrier and apply sealant to housing side.
"A": Sealant 99000-31110
6. Install differential carrier assembly to axle housing and tighten carrier nuts to specified torque.
Tightening Torque (a): 55 Nm (5.5 kg-m, 40.0 ft. lbs.)
7. For vehicle with ABS, connect wheel speed sensor coupler and install harness.
8. Install propeller shaft and torque nuts to specification.
Tightening Torque (b): 50 Nm (5.0 kg-m, 36.5 ft. lbs.)
9. Remove floor jack from axle housing and connect breather hose onto axle housing and clamp it securely.
10. Connect brake pipes onto axle housing and clamp them securely. For clamping positions, refer to Brakes and Traction Control.
11. Connect brake flexible hose to bracket on axle housing and secure it with E-ring.
