Grand Vitara JLS Plus 2WD V6-2.5L (2000)
3. Tapping yoke with a hammer, completely remove bearing race.
4. Take out bearing race on the other side in the same way as in 2) and 3).
5. Push out bearing race on flange yoke side as described in 1) and 2), and then, holding bearing race in a vise, tap flange yoke and take out race.
(Refer to the figure.)
Remove bearing race on the opposite side in the same way.
NOTE:
-
Take care not to lose rollers in spider bearing race when removing it.
-
Fit removed bearings temporarily in spider so that they can be reinstalled in their original positions.
INSPECTION
Inspect propeller shaft and flange yoke for damage, and propeller shaft for runout.
If damage is found or shaft runout exceeds its limit, replace.
Runout limit: 0.8 mm (0.031 inch)
ASSEMBLY