Grand Vitara JLS Plus 2WD V6-2.5L (2000)
Seals and Gaskets: Service and Repair
REMOVAL AND INSTALLATION
1. Remove propeller shaft.
2. Using screwdriver, remove oil seal.
3. Using special tool (A) and plastic hammer, press fit new oil seal into extension case till oil seal contacts stepped part of extension case as shown.
Be sure to apply grease to oil seal lip.
"A": Grease 99000-25010
Special Tool
(A): 09951-16060
4. Clean and inspect sliding portion of propeller shaft front end (where oil seal contacts) before installation and if even small dent or scratch exists,
correct and clean it again. Then apply grease inside splines of propeller shaft.
"B": Grease 99000-25010
5. Install propeller shaft.
