Grand Vitara LTD 2WD V6-2.5L (2001)
Hydraulic Control Assembly - Antilock Brakes: Testing and Inspection
PRECAUTION
When connector are connected to ABS hydraulic unit/control module assembly, do not disconnect connectors of sensors and turn ignition switch ON.
Then DTC will be set in ABS control module.
ABS HYDRAULIC UNIT OPERATION CHECK
1. Check that basic brake system other than ABS is in good condition.
2. Check that battery voltage is 11 V or higher.
3. With "ABS" warning lamp, check that no abnormality is detected in ABS.
4. Lift up vehicle.
5. Set transmission to neutral and release parking brake.
6. Turn each wheel gradually by hand to check if brake dragging occurs. If it does, correct.
7. With diag. switch terminal (2) of diagnosis connector (1) connected to ground by using service wire (4), turn ignition switch to ON position and
check that "ABS" warning lamp indicates normal DTC (DTC 12).
8. Turn ignition switch to OFF position.
9. Perform following checks with help of another person.
a. Brake pedal (1) should be depressed.
b. Ignition switch turned to ON position by one person.
c. Wheel should be turned by another person's hand. At this time, check that:
^
Operation sound of solenoid is heard and wheel turns only about 0.5 seconds (brake force is repressurized).
