Grand Vitara LTD 2WD V6-2.5L (2001)
2. Tighten wheel cylinder to brake back plate (1) to specified torque.
Tightening torque
Wheel cylinder bolt (for non sealed type) (a): 8.5 Nm (0.85 kg-m, 6.5 ft. lbs.)
3. Torque flare nut (or nuts) (2) of brake pipe (3) which was connected in step 1) to specification.
Tightening torque
Brake pipe flare nut (b): 16 Nm (1.6 kg-m, 12.0 ft. lbs.)
4. Install bleeder plug cap taken off from pipe back to bleeder plug.
5. For procedure hereafter, refer to steps 1) to 5) of BRAKE SHOE INSTALLATION.
See: Brake Shoe
NOTE: Be sure to bleed brake system.
For Gasket Sealed Type
1. Install gasket (2) to joint seam of wheel cylinder (1) and brake back plate. Then take off bleeder plug cap from brake pipe and connect pipe (or
pipes) to wheel cylinder just enough to prevent fluid from leaking.
NOTE: Be sure to check gasket for deterioration or any damage before installation and replace if found defective.