Grand Vitara LTD 2WD V6-2.5L (2001)
23 N.m (2.3 kg-m, 16.5 lb-ft)
Bolt Tightening torque:
10 N.m (1.0 kg-m, 7.0 lb-ft)
16.
Install the fuel pump relay.
17.
Connect the negative cable to the battery and reset the radio stations and clock.
18.
Turn ON the ignition switch for 3 seconds (to operate the fuel pump) and then turn it OFF. Repeat this cycle 3 or 4 times to fully pressurize the
system. With the ignition switch OFF confirm that there is no leakage from any part of the fuel system. Run the engine and confirm that there are
no leaks.
D. Campaign Sticker Installation Procedure
Install the Red X4 Recall Campaign sticker to the flat surface on the upper radiator support, just above the left headlamp (Figure 1). This will identify
that the fuel pressure regulator and vacuum hose union replacement has been completed.
