Grand Vitara LTD JLX 4WD V6-2.5L (2000)
7. Remove coil spring.
INSTALLATION
1. Install coil spring on spring seat of axle housing and then raise axle housing.
NOTE: When seating coil spring, mate spring end with stepped part of rear axle spring seat as shown.
2. Install shock absorber lower bolt. For its proper installing direction, refer to figure. Nut should not be tightened.
3. Install wheel speed sensor clamp (if equipped) and E-ring, and connect breather hose to axle housing.
4. Connect cable hanger to chassis frame and clamp to cross member. Remove floor jack from axle housing.
