Kizashi AWD L4-2.4L (2010)
If the remote controller will not register and the "Cancel" button is pressed, the SDT scan tool will end the registration process and go to the Immobilizer
start screen. DO NOT TURN OFF THE IGNITION, this will result in the need to replace the controller. Simply begin the registration process again,
using the same passwords as before.
43. Once the remote controller is recognized, the screen will change to read "The remote controller was registered.
44. Press "Next" to continue programming the remaining remote controllers, and continue to Step 45. If only one remote controller is being registered,
press "Exit" and jump to Step 50.
45. Set the registered remote aside where it won't be confused with those remaining to be registered.
46. Keeping the SDT powered on, push the Engine Start/Stop button once to turn the ignition "Off" (the warning lights in instrument panel will go off),
then push Engine Start/Stop button twice more to turn the ignition back on.
47. Hold another remote controller up to the Engine Start/Stop button and press "Next".
