Kizashi AWD L4-2.4L (2010)
3) Install camshaft bearings using the following procedures:
CAUTION:
When installing, distinguish between upper bearing (1) and lower bearing (2) referring to the following figure.
a) Fit tab (1) of camshaft bearing to groove (2) of cylinder head or camshaft housing.
b) Press camshaft bearing end (3) until it is firmly seated on the cylinder head or camshaft housing.
c) Apply engine oil to sliding surface (4) of camshaft bearing halves.
CAUTION:
Do not apply engine oil between bearing halves (5) and camshaft housing or cylinder head (5).
