Kizashi AWD L4-2.4L (2010)
Idle Speed: Testing and Inspection
Idle Speed Inspection
Before idle speed check, make sure of the following.
-
Lead wires, pipes and hoses of electronic fuel injection and engine and emission control systems are connected securely.
-
Ignition timing is within specification.
-
All electrical systems (wipers, heater, lights, A/C, etc.) are out of service.
-
Air cleaner has been properly installed and is in good condition.
-
There are no abnormal air drawn in from air intake system.
-
There are no obstruction in PCV valve or its hoses.
-
There are no DTC in ECM.
-
Check following item turn OFF by using "Data List" mode on scan tool.
-
A/C Comp Relay
-
A/C Switch
-
Brake Switch
-
Electric Load
-
Blower Fan
After confirming all items, check idle speed and IAC throttle opening as follows.
NOTE: Before starting engine, place gear shift lever in "Neutral" (M/T model) or select lever in "P" range (CVT model), and set parking brake and
block drive wheels.
1. With ignition mode of keyless push start system in "OFF" and connect SUZUKI scan tool to DLC (1).
Special Tool
(A): SUZUKI scan tool (SUZUKI-SDT)
