Kizashi AWD L4-2.4L (2010)
Circuit Description
When push engine switch to change ignition mode to "ON", the main relay turns ON (the contact point closes) and the main power is supplied to ECM.
And then ECM supplies 5 V power to each sensor (A/C refrigerant pressure sensor, EVAP leak check pressure sensor, APP sensor and TP sensor).
Troubleshooting
NOTE:
-
Before troubleshooting, perform following items.
-
Be sure to read "Precautions for ECM Circuit Inspection" under Precautions for Engine.
-
When measuring circuit voltage and/or pulse signal at ECM connector, connect special tool to ECM and ECM connectors.
-
Be sure to confirm related fuses of ECM power circuit for not blown out. If fuse is blown out, replace fuse(s) and check circuits connected to
blown fuse(s) for short circuit to ground.
-
Confirm that battery voltage is 12 V or more.
-
For "Ignition mode" described in the following table, it means power supply mode in keyless push start system.
For more details of ignition mode, refer to Description of Keyless Engine Start Function.
1. Check ECM power supply circuit as follows.
a. Confirm that ignition mode of keyless push start system is "OFF".
