Kizashi AWD L4-2.4L (2010)
Accelerator Pedal Position Sensor: Service and Repair
Accelerator Pedal Assembly (Incorporating APP Sensor) Removal And Installation
CAUTION:
-
Do not drop accelerator pedal assembly or subject it to strong impact. If the accelerator pedal assembly is subjected to strong impact it
must be replaced.
-
Be careful not to expose sensor section of accelerator pedal assembly (incorporating APP sensor) to water and oil.
-
Do not disassemble accelerator pedal assembly (incorporating APP sensor).
NOTE: After replacing accelerator pedal assembly (incorporating APP sensor), calibrate throttle valve position.
Removal
1. Disconnect negative (-) cable at battery.
2. Remove instrument panel undercover.
3. Disconnect connector from accelerator pedal assembly (incorporating APP sensor).
4. Remove accelerator pedal assembly (incorporating APP sensor) from its bracket.
5. Remove accelerator pedal assembly bracket from vehicle body.
Installation
1. Tighten accelerator pedal assembly bracket nuts (1) to specified torque in numerical order ("1" - "3").
Tightening torque
Accelerator pedal assembly bracket nut (a): 13 N.m (1.3 kg-m, 9.5 lbf-ft)
2. Tighten accelerator pedal assembly nuts (2) to specified torque in numerical order ("1" - "2").
Tightening torque
Accelerator pedal assembly nut (b): 13 N.m (1.3 kg-m, 9.5 lbf-ft)
