Kizashi AWD L4-2.4L (2010)
Accelerator Pedal Position Sensor: Testing and Inspection
APP Sensor On-Vehicle Inspection
APP Sensor On-vehicle Inspection
CAUTION:
-
Do not drop accelerator pedal assembly or subject it to strong impact. If the accelerator pedal assembly (incorporating APP sensor) is
subjected to strong impact it must be replaced.
-
Be careful not to expose sensor section of accelerator pedal assembly (incorporating APP sensor) to water and oil.
-
Do not disassemble accelerator pedal assembly (incorporating APP sensor).
1. Check that accelerator pedal assembly (incorporating APP sensor) has been mounted to vehicle body properly (no pinched floor carpet, etc.).
Reinstall accelerator pedal assembly (incorporating APP sensor) if it is not properly mounted.
2. Connect SUZUKI scan tool to DLC with ignition mode of keyless push start system in "OFF".
3. Push engine switch to change the ignition mode to "ON", select "Data List" mode on SUZUKI scan tool.
4. Check that voltage varies depending on accelerator position as the following graph.
If faulty condition is found, check the following points:
-
Wire harness and connections
-
APP sensor: See: APP Sensor Inspection
