Kizashi AWD L4-2.4L (2010)
Ambient Light Sensor: Programming and Relearning
Rain / Light Sensor Initialization (If Equipped)
Rain / Light Sensor Setting Description
Rain / light sensor has a reference amount of light reflected off the windshield in memory. The rain-sensing wiper system controls wiper operation based
on change in amount of the reflected light. After doing any of the following service operations, the reference light amount value in sensor memory is
cleared or changed, so the sensor must be initialized.
-
Replacement of rain / light sensor
-
Replacement of windshield
Initialization
1. Check that vehicle is in the following conditions.
-
There is no dirt, dust or air bubbles on windshield mounting surface of rain / light sensor.
-
Ignition mode of keyless push start system is "OFF".
-
Wiper and washer switch is OFF.
-
Lighting switch is OFF.
-
Wipers are at park positions.
-
Temperature around rain / light sensor is 5 to 40 °C (41 to 120 °F).
-
Vehicle is stopped.
-
Adjustment knob (1) is as shown in figure.
2. Push engine switch to change ignition mode of keyless push start system to "ON".
3. Check that clearance lights are flashing at 1-second interval.
NOTE: If clearance lights operate repeating a 3-second on, 1-second off cycle, rain / light sensor may be abnormal. Perform diagnosis in this
case.
4. Operate adjustment knob within 4 seconds in the following procedure.
a. Set adjustment knob to 1.
b. Set adjustment knob to 5.
