Kizashi AWD L4-2.4L (2010)
Power Window Switch: Testing and Inspection
Inspection of Power Window Master Switch and Its Circuit
Inspection Of Power Window Master Switch And Its Circuit
Voltage and Signal Check
1. Remove door trim and power window master switch.
2. Connect connector to power window master switch and push engine switch to change ignition mode of keyless start system to "ON" or start
engine.
3. Check terminal voltages and waveforms using voltmeter and oscilloscope.
NOTE:
-
Confirm that battery voltage is 11 V or more.
-
An "ignition mode" in the following table represents a power supply mode available with the keyless start system. For more details, refer to
Description of Keyless Engine Start Function.
-
Outputs from terminals marked with asterisk (*) cannot be measured with voltmeter because they are pulse signals. Use oscilloscope function
of SUZUKI scan tool for measuring these outputs.
Reference Waveform
Oscilloscope display
