Reno L4-2.0L (2006)
Wheel Speed Sensor: Service and Repair
Front Wheel Speed Sensor Jumper Harness Removal and Installation
Front Wheel Speed Sensor Jumper Harness Removal and Installation
Removal
1. Disconnect the negative battery cable.
2. Disconnect connector from the EBCM.
3. Remove the appropriate terminals from connector:
^
Right-side - terminals 5 (WHT) and 6 (GRY).
^
Left-side - terminals 9 (BRN) and 8 (LT BLU).
4. Both speed sensor harnesses break out of the ABS wiring harness just beyond the ABS connector. The right-side speed sensor harness crosses the
top of the fire wall to the right side fender area. The left-side speed sensor harness goes directly to the left-side fender area.
5. Free the speed sensor harness from the wiring harness.
6. Remove the front wheel speed sensor electrical connector from the retaining clamps and disconnect the harness from the sensor connector.
