Reno L4-2.0L (2006)
7. Install the connecting rod bearing cap bolts.
Tighten: Tighten the connecting rod bearing cap bolts to 35 Nm (26 ft. lbs.). Using the angular torque gauge KM-470-B, tighten the connecting
rod bearing cap bolts another 45° plus 15°.
8. Remove the connecting rod bearing caps.
9. Measure the width of the flattened plastic thread of the plastic gauging using a ruler. (Plastic gauging is available for different tolerance ranges.)
10. Inspect the bearing clearance for permissible tolerance ranges.
