Reno L4-2.0L (2006)
9. Have an assistant support the heater/air distributor case from inside the vehicle.
10. Remove the screws that secure the heater/air distributor case assembly to the firewall on the side of the evaporator.
11. Disconnect the rear duct connector.
12. Remove the heater/air distributor case assembly from the vehicle.
Installation
1. Position the heater/air distributor case assembly in the vehicle.
2. Slowly raise the heater/air distributor case assembly into position against the firewall and hold it in position while the screws are installed and
tightened from the engine side of the firewall.
3. Install the high-pressure and low-pressure pipe.
4. Install the heater/air distributor case assembly screws at the side of evaporator through the firewall from the engine compartment side.
Tighten: Tighten the heater/air distributor case assembly screws to 4 Nm (35 in. lbs.).
5. Install the heater/air distributor case assembly screws at the side of the heater core pipes through the firewall from the engine compartment side.
Tighten: Tighten the heater/air distributor case assembly screw to 4 Nm (35 in. lbs.).
6. Install the two heater hoses.
7. Slide the heater hose clamps into position.
