Reno L4-2.0L (2006)
11. Remove the liquid pipe block-to-receiver dryer retaining nut.
12. Remove the bolts which secure the support clamps that hold the liquid pipe to the vehicle.
13. Remove the liquid pipe from the vehicle.
14. Cap the opening at the receiver-dryer to prevent contamination.
Installation
1. Position the liquid pipe into the vehicle.
2. Install the liquid pipe support clamp bolts.
Tighten: Tighten the liquid pipe support clamp bolts to 4 Nm (35 in. lbs.).
3. Install a new O-ring on the pipe at the receiver dryer.
4. Install the liquid pipe block-to-receiver-dryer retaining nut.
Tighten: Tighten the liquid pipe block-to-receiver-dryer retaining nut to 14 Nm (10 ft. lbs.).
