Reno L4-2.0L (2006)
Housing Assembly HVAC: Service and Repair
Heater / Air Distributor Case Assembly
Removal
1. Disconnect the negative battery cable.
2. Remove the instrument panel and tie-bar.
3. Drain the cooling system. Refer to Draining and Refilling the Cooling System.
4. Compress the heater hose clamps at the firewall and slide the clamps toward the engine.
5. Remove the 2 heater hoses from the core pipes at the firewall.
6. Remove the screws that secure the heater/air distributor case assembly to the firewall on the side of the heater core pipes.
7. Remove the high-pressure and Low-pressure pipe from the A/C expansion valve.
8. Remove the evaporator drain hose.
9. Have an assistant support the heater/air distributor case from inside the vehicle.
10. Remove the screws that secure the heater/air distributor case assembly to the firewall on the side of the evaporator.
11. Disconnect the rear duct connector.
