Reno L4-2.0L (2006)
6. Slowly push and hold the brake pedal one time.
7. Loosen the front brake line at the master cylinder to purge air from the cylinder.
8. Tighten the brake line (as in step 5), and then release the brake pedal slowly. Wait 15 seconds before proceeding to the next step.
9. Repeat the sequence, including the 15-second wait, until all the air is removed from the master cylinder bore.
10. After all the air has been removed at the forward connection(s), bleed the master cylinder at the rear (cowl) connection(s) in the same manner as
with the front connections.
