Reno L4-2.0L (2006)
Installation
1. Lubricate any new O-ring seals with power steering fluid.
2. Place the O-ring seals into the housing and install the steering gear hydraulic cylinder pipes.
3. Connect the power steering gear hydraulic cylinder pipes to the power steering gear at the valve end.
Tighten:
Tighten the hydraulic cylinder line fittings at the valve end to 18 Nm (13 ft. lbs.).
4. Connect the power steering gear hydraulic cylinder pipes to the power steering gear at the cylinder end.
Tighten:
Tighten the hydraulic cylinder line fittings at the cylinder end to 28 Nm (21 ft. lbs.).
