Reno L4-2.0L (2006)
2.
Download and review the Suzuki Pass-Thru Reprogramming Tool Operator's Manual. This must be read and understood COMPLETELY before
attempting to reprogram the ECM.
3.
Following the procedure outlined in the Suzuki Pass-Thru Reprogramming Tool Operator's Manual, download and install the Pass-Thru
Reprogramming Software "SOFTWARE.EXE" in your PC, (if it is not already installed).
4.
Follow the procedure in Section 3.2 of the Operator's Manual to update the Database files. Download and unzip Suzuki Pass-Thru Reprogramming
Data Base "DATABASE.EXE" in your PC. This step is only required to be done once to accommodate all vehicles covered under this TSB.
NOTE:
This Database "DATABASE.EXE" has been updated with newer data for reprogramming without changing the file name. You are requested
to download in order to update the database in your PC.
5.
Following the procedures outlined in the Suzuki Pass-Thru Reprogramming Tool Operator's Manual, hook up the SDS Interface Tool P/N
09910-06520 to the vehicle and run the ECM reprogramming software. Continue to step 6. If the message "[4028] ECU already has the latest
version" appears, click "OK". No further action is required. The glove box label should already be in the glove box.
6.
Fill out the Reprogram Label P/N 99963-01501-224 (the part number and version will be displayed at the "The reprogramming is successful"
screen). Then affix the label to the back of the glove box door as pictured below.
7.
Perform the idle relearn after reprogramming as follows.
a.
Turn the ignition ON.
b.
Turn the ignition OFF for 15 seconds.
c.
Turn the ignition ON for 5 seconds.
d.
Turn the ignition OFF for 15 seconds.
e.
Start the engine in Park/Neutral.
f.
Allow the engine to run until the engine coolant is above 85 °C (185 °F).
g.
Turn the A/C ON for 10 seconds, if equipped.
h.
Apply the parking brake. While pressing the brake pedal, place the transaxle in D (Drive) for 10 seconds.
i.
Turn the A/C OFF for 10 seconds, if equipped.
j.
Place the transaxle in Park/Neutral.
k.
Turn the ignition OFF. The idle learn procedure is complete.
l.
Perform Tooth Error Correction (TEC) relearn by using the Tech 2.
