Reno L4-2.0L (2006)
Transmission Position Switch/Sensor: Service and Repair
Park/Neutral Start Switch Removal and Installation
Removal
1. Disconnect the negative battery cable.
2. Disconnect the park/neutral position switch electrical connector.
3. Disconnect the shift control cable and the retaining clip.
4. Remove the shift lever nut and the shift lever.
5. Remove the park/neutral start switch.
Installation
Tools Required: DW260-050 P/N Switch Installer
1. Install the park/neutral start switch.
^
Tighten the bolts to 10 Nm (89 inch lbs.).
