Reno L4-2.0L (2006)
Air Bag Control Module: Testing and Inspection
Handling, Installation and Diagnosis
^
Airbag modules should not be subjected to temperature above 65 degrees Celsius (149 degrees Fahrenheit).
^
An airbag and SDM should not be used if it has been dropped from height of 0.9 meters (3 feet) or greater.
^
When an SDM is replaced, it must be oriented with the arrow on the SDM pointing toward the front of the vehicle.
^
It is very important for the SDM to be installed flat on the mounting surface, parallel to the vehicle's longitudinal axis.
^
To avoid setting diagnostic trouble codes(DTCs), do not apply power to the SIR unless all components are connected or a diagnostic chart request
it.
^
The SIR Diagnostic System Check must be the starting point of any SIR diagnostics. The SIR Diagnostic System Check will verify proper airbag
indicator operation and will lead you to correct chart to diagnose any SIR malfunctions. Bypassing these procedures may result in extended
diagnostic time and incorrect parts replacement.
