Reno L4-2.0L (2006)
plenty of slack for the seat to move all the way forward and aft without putting any tension on the harness. Then wire tie both harnesses into
position.
10.
Re-connect the buckle switch connector. re-use
11.
Slide the passenger seat 5 notches back and replace the buckle with the same process. The passenger buckle does not have a wiring harness. Do
not remove any wire ties. Torque the bolt to 42 Nm (31 lb- ft).
12.
Re-install the center console by sliding the front section into place first.
13.
Engage the tabs properly before securing the console. Secure the console with the two removed screws from step 2.
