Reno L4-2.0L (2006)
Impact Sensor: Service and Repair
Side Airbag Sensor Removal and Installation
WARNING: The Sensing and Diagnostic Module (SDM) can maintain sufficient voltage to deploy the airbags and pretensioners for 1 minute
after the ignition is OFF and the fuse has been removed. If the airbags and pretensioners are not disconnected, do not begin service until 1
minute has passed after disconnecting power to SDM. If the airbags are disconnected, service can be done immediately without waiting for
1-minute time period to expire. Failure to temporarily disable the SIR during service can result in unexpected deployment, personal injury and
unnecessary SIR repairs.
1. Disconnect the negative battery cable.
2. Remove the trim from B-pillar.
3. Remove the side airbag sensor mounting bolts.
4. Remove the side airbag sensor.
Installation
Installation should follow the removal procedure in the reverse order.
^
Tightening torque of the side airbag sensor mounting bolts is 10 Nm (89 lb.in).
