Reno L4-2.0L (2006)
time, or all of the tests pass.
>
If there is an impending failure, the system may require more time to run the diagnostic than was allotted in the set procedure. If the test does not
run after numerous attempts and no DTC is set, review the appropriate scan tool data list and review the service information for an indication of
why the test does not complete. Some tests may abort due to changes in the conditions while the test is running. For example, changes in the
engine load, such as a cooling fan or an A/C compressor clutch turning on, may cause the test to abort.
>
If a diagnostic test is difficult to run, observe the scan tool display while maintaining the necessary enable conditions until the readiness status
updates to YES.
Step Action
1. Connect scan tool to DLC with ignition switch OFF
2. Start engine.
3. Idle vehicle for 2 minutes.
4. Check DTC by using scan tool.
