Reno L4-2.0L (2006)
Front Steering Knuckle: Removal and Replacement
Front Suspension
Knuckle Assembly Removal and Installation
Tools Required: KM-507-B Ball Joint Remover
Removal
1. Raise and suitably support the vehicle.
2. Remove the wheel.
3. Remove the caulking nut from the axle shaft.
4. Remove the brake caliper from the rotor. Support the caliper so it does not hang from the hydraulic brake hose.
5. Remove the outer tie rod from the knuckle assembly.
6. On vehicles equipped with the antilock braking system (ABS), disconnect the ABS speed sensor electrical connection from the knuckle.
7. Remove the ball joint pinch bolt and the nut.