Reno L4-2.0L (2006)
8. Separate the knuckle from the ball joint using the ball joint remover KM-507-B.
9. Remove the nuts from the bolts that connect the knuckle assembly to the strut assembly.
10. Support the drive axle.
11. Separate the drive axle shaft from the wheel hub.
12. Remove the bolts that connect the knuckle assembly to the strut assembly.
13. Remove the knuckle assembly from the vehicle.
Installation
1. Install the knuckle assembly onto the vehicle.
2. Install the steering knuckle-to-strut assembly nuts.
^
Tighten the steering knuckle-to-strut assembly nuts to 120 Nm (89 ft. lbs.).
