Reno L4-2.0L (2006)
2. Install the seal onto the axle shaft.
3. Install the shaft retaining ring onto the axle shaft using the snap ring pliers J-8059.
4. Fill the tripot housing with 195 to 215 g (6.9 to 7.6 ounces) of the recommended grease.
Repack the tripot with 195 to 215 g (6.9 to 7.6 ounces) of the recommended grease.
5. Install the boot to the joint housing.
6. Install a new large seal retaining clamp. Crimp the large seal retaining clamp using the seal clamp pliers J-35566.
7. Crimp the new small seal retaining clamp using the seal clamp pliers J-35566.
