Reno L4-2.0L (2006)
3. Fill the joint seal with 110 to 130 g (3.9 to 4.6 ounces) of the recommended grease. Repack the joint with 110 to 130 g (3.9 to 4.6 ounces) of the
recommended grease.
^
1.8 DOHC: 120 to 140 g (4.2 to 4.9 ounces)
4. Install a new large seal retaining clamp and a new small seal retaining clamp.
5. Crimp the new small seal retaining clamp and the new large seal retaining clamp using the seal clamp pliers J-35566.
6. Install the drive axle shaft to the vehicle.
Inner Tripot Boot Removal and Installation
Inner Tripot Seal Removal and Installation
Tools Required:
J-35566 Snap Clamp Pliers
J-8059 Snap Ring Pliers
Removal
1. Remove the drive axle from the vehicle.
2. Remove the large seal retaining clamp. Discard the clamp.
3. Remove the small seal retaining clamp. Discard the clamp.
