Reno L4-2.0L (2006)
Shift Linkage: Service and Repair
Shift Linkage Assembly Removal and Installation
Removal
1. Disconnect the negative battery cable.
2. Remove the rod clamp.
3. Remove the clip and the bolt from universal joint.
4. Separate the universal joint from the transaxle.
5. Remove the fixing shaft pin and separate the linkage connection part from the transaxle rear mounting bracket.
6. Remove the shift linkage assembly.
Installation
1. Install the shift linkage assembly.
2. Install the fixing shaft pin and connect the linkage connection part to the transaxle rear mounting bracket.
3. Install the universal joint to the transaxle.
4. Install the clip and the bolt from universal joint.
5. Install the rod clamp.
6. Adjust the shift linkage.