Samurai 2WD L4-1324cc 1.3L SOHC 5 Carb 8V (1987)
12.
Remove tie rod end castle nut, then using tie rod remover 09913-65210, or equivalent, disconnect tie rod from steering knuckle, Fig. 3.
13.
Remove joint seal attaching bolts, then oil seal cover, pad, oil seal and retainer from knuckle.
14.
Remove upper and lower kingpins.When removing kingpins, mark with identification marks for installation. Also, check number of shims
used for each side.
15.
Pull off steering knuckle. When removing steering knuckle, kingpin lower bearing may fall out. Mark upper and lower kingpin bearings
for installation.
16.
Drain oil from differential housing.
17.
Remove axle shaft joint from axle housing.
18.
Reverse procedure to install.
